HD JB 12kV-630A European Separable Front Connector
For connection of polymeric cable to transformers.switchgear ,motors and other equipment with a premoulded separable connector.
*For connection of polymeric cable to transformers.switchgear ,motors and other equipment with a premoulded separable connector.
*For indoor and outdoor installations.
*Continuous operating voltage: 8 .7/15kV
* Continuous current 630A; (900A overload for 8 hours )
*Connect to (JBK) coupling connector or (HBLQ) surge arrester to enable multi-loop installation or provide over voltage protection.
*Cable particulars:
- Copper or aluminum conductors
- Semiconducting or metallic screens
- Conductor cross section: 12kV 25-500mm2）
——Features
Provides a fully screened and fully submersible sparable connection when mated with the
proper bushing or plug.
Can be used under the Circumstances,
" Built-in capacitive est point to determine the circuit status or install a fault indicator.
。No minimum phase clearance requirements.
" Mounting can be vertical, horizontal or any angle in between.
——scope of delivery
* T Fore connector
* Stress cone
* insulator
* Covering cap
* Conductor cable lug (Copper or copper )
* Socket wrench
* M16/ 12screwstud
* M12 nuts,flat washers,spring washers
* tape
* sandpaper
* Utility Knife
* Bandage
* Clean paper
* Silicone grease
* Gloves (white,yellow)
* Gloves(disposable)
* Sealant (red)
* cable ties(snap)
* PVC electrical tape (red,yellow,green)
* Quality Certificate
* Installation instruction sheet
The key words of this product:
Welcome to our website! Please send your words at any time in the following form and ask us, we will contact you and provide you with the corresponding service in 24 hours. Please write in English.
HD DJTG 12kV-630A Deadbreak Bushing
630A deadbreak bushing,mainly for European cable branch box,Connect to former Continental,it can be connected with live indicator, charging status display bus, The use of high-quality epoxy resin insulation.
Learn More